Design and Analysis of a Low-Power 45 nm CMOS LNA for 2.4 GHz BLE Receivers Using Inductive Degeneration and PCSNIM Technique
Cornelia Zefanya, Dzuhri Radityo Utomo, S.T., M.S., Ph.D.;Ir. Prapto Nugroho, S.T., M.Eng., D.Eng., IPM.
2026 | Skripsi | TEKNIK ELEKTRO
Penerima Bluetooth Low Energy (BLE) membutuhkan penguat front-end berdaya rendah dengan noise figure minimum untuk mencapai sensitivitas yang memadai. Penelitian ini memaparkan perancangan dan analisis Low Noise Amplifier (LNA) CMOS 2,4 GHz berdaya rendah untuk aplikasi penerima BLE dengan menggunakan teknologi CMOS 45 nm gpdk045. Teknik Power-Constrained Simultaneous Noise and Input Matching (PCSNIM) diterapkan pada topologi kaskode dengan inductive source degeneration untuk mencapai noise dan impedance matching secara bersamaan dengan batasan daya tertentu. Proses desain diawali dengan simulasi parametric sweep untuk menentukan nilai komponen awal, dilanjutkan dengan tuning iteratif pada tingkat skematik. Analisis non-idealitas dilakukan secara sistematis untuk mengidentifikasi penyebab utama penurunan kinerja saat beralih dari komponen ideal ke riil. Hasilnya menunjukkan bahwa induktor gerbang merupakan penyumbang degradasi terbesar akibat rugi-rugi resistif pada induktor spiral on-chip yang berukuran besar.
Simulasi post-layout yang menggunakan parasitic-extracted netlist menghasilkan noise figure 2,97 dB, input return loss -30,19 dB, gain 17,99 dB, dan konsumsi daya 2,1 mW dengan tegangan catu 1 V. Seluruh hasil tersebut telah memenuhi spesifikasi target BLE dan membuktikan bahwa teknik PCSNIM sangat layak diterapkan untuk desain LNA berdaya rendah pada teknologi CMOS 45 nm.
Bluetooth Low Energy (BLE) receivers require low-power front-end amplifiers with minimal noise figure to achieve adequate receiver sensitivity. This research presents the design and analysis of a 2.4 GHz low-power CMOS Low Noise Amplifier (LNA) for BLE receiver applications, implemented in the gpdk045 45 nm CMOS technology. The Power-Constrained Simultaneous Noise and Input Matching (PCSNIM) technique is applied to a cascode topology with inductive source degeneration to achieve near-simultaneous noise and impedance matching under a constrained power budget. The design process employs sequential parametric sweep simulations to establish preliminary component values, followed by iterative tuning at the schematic level. A systematic non-ideality analysis is conducted to identify the dominant source of performance degradation when transitioning from ideal to real components, revealing that the gate inductor is the primary contributor due to resistive losses in large on-chip spiral inductors.
Post-layout simulation using a parasitic-extracted netlist yields a noise figure of 2.97 dB, an input return loss of -30.19 dB, an LNA gain of 17.99 dB, and a power consumption of 2.1 mW from a 1 V supply, all meeting the BLE target specifications. The results validate the applicability of the PCSNIM technique for low-power LNA design in 45 nm CMOS technology.
Kata Kunci : Low Noise Amplifier (LNA), PCSNIM, Bluetooth Low Energy (BLE), CMOS, 45 nm, Noise Figure, Inductive Source Degeneration