Desain Instrumentation Amplifier pada Teknologi CMOS 45 nm untuk Aplikasi Low-Side Current Sensing pada Power Management IC
Muhammad Luqman, Ir. Prapto Nugroho, S.T., M.Eng., D.Eng., IPM.; Dzuhri Radityo Utomo, S.T., M.S., Ph.D.
2026 | Skripsi | TEKNIK ELEKTRO
Kebutuhan terhadap sistem Power Management Integrated Circuit (PMIC) yang efisien mendorong pengembangan blok pengukuran arus yang mampu membaca tegangan kecil pada resistor shunt secara cepat, stabil, dan hemat daya. Pada konfigurasi low-side current sensing, tegangan common-mode masukan berada dekat 0 V sehingga arsitektur Instrumentation Amplifier (INA) tiga operational amplifier (op-amp) sesuai untuk digunakan karena memiliki impedansi masukan tinggi, penguatan diferensial yang dapat diatur melalui rasio resistor, serta kemampuan menolak sinyal common-mode. Penelitian ini mengusulkan rancangan INA tiga op-amp berbasis tiga buah two-stage Miller-compensated operational transconductance amplifier (OTA) pada teknologi CMOS 45 nm untuk aplikasi low-side current sensing pada PMIC.
Proses perancangan dilakukan melalui penurunan spesifikasi dari kebutuhan sistem PMIC, analisis arsitektur OTA dua tahap dengan kompensasi Miller, penentuan parameter awal transistor dan resistor, optimisasi rangkaian, serta verifikasi menggunakan simulasi pre-layout dan post-layout pada Cadence Virtuoso dengan process design kit (PDK) GPDK045. Jaringan resistor INA menggunakan RG = 1 k?, R1 = R2 = 25 k?, R3 = R4 = 4 k?, dan R5 = R6 = 48 k?. Hasil simulasi pre-layout menunjukkan penguatan diferensial sebesar 42,94 dB, bandwidth 504,84 kHz, common-mode rejection ratio (CMRR) 78,76 dB, slew rate 1,999 V/µs, settling time 1,512 µs, input-referred noise 62,831 µV/?Hz pada 1 Hz, dan disipasi daya 160,9 µW. Setelah ekstraksi parasitik, rancangan tetap memenuhi target dengan penguatan diferensial 42,72 dB, bandwidth 496,68 kHz, CMRR 77,54 dB, slew rate 1,943 V/µs, settling time 1,529 µs, disipasi daya 159,6 µW, dan luas area layout 946,8015 µm². Dengan demikian, rancangan INA yang diusulkan memenuhi spesifikasi utama untuk aplikasi low-side current sensing pada PMIC dan menunjukkan ketangguhan terhadap parasitik layout pada tingkat sistem.
The need for efficient Power Management Integrated Circuit (PMIC) systems dri
ves the development of current-sensing blocks capable of detecting small voltages across
a shunt resistor with sufficient speed, stability, and low power consumption. In a low-side
current-sensing configuration, the input common-mode voltage is close to 0 V; therefore,
a three-OpAmp Instrumentation Amplifier (INA) is suitable because it provides high input
impedance, resistor-ratio-based differential gain, and common-mode rejection capability.
This research proposes a three-OpAmp INA using three Two-Stage Miller-Compensated
Operational Transconductance Amplifiers (OTAs) in 45 nm CMOS technology for PMIC
low-side current-sensing applications.
The design process consists of deriving the specifications from PMIC system re
quirements, analyzing the two-stage Miller-compensated OTA architecture, determining
the initial transistor and resistor parameters, optimizing the circuit, and verifying the de
sign through pre-layout and post-layout simulations using Cadence Virtuoso with the
GPDK045 PDK. The INA resistor network uses RG = 1 k?, R1 = R2 = 25 k?,
R3 = R4 = 4k?, and R5 = R6 = 48 k?. The pre-layout simulation achieves a di
fferential gain of 42.94 dB, bandwidth of 504.84 kHz, CMRR of 78.76 dB, slew rate of
1.999 V/µs, settling time of 1.512 µs, input-referred noise of 62.831 µV/?Hz at 1 Hz,
and power dissipation of 160.9 µW. After parasitic extraction, the design still satisfies
the target specifications with a differential gain of 42.72 dB, bandwidth of 496.68 kHz,
CMRR of 77.54dB,slewrateof1.943V/µs, settling time of 1.529 µs, power dissipation of
159.6 µW, and layout area of 946.8015 µm2. Therefore, the proposed INA design meets
the main specifications for PMIC low-side current sensing and demonstrates system-level
robustness against layout parasitics.
Kata Kunci : Instrumentation Amplifier, Two-Stage OTA, Kompensasi Miller, Low-Side Current Sensing, CMOS 45 nm