Perancangan Pembangkit Listrik Tenaga Surya Pada Kontainer Di Pusat Inovasi Agroteknologi Universitas Gadjah Mada
Franciskus Genta Permana Riyanto, Dr.Ing. Ir. Sihana. ; Dr. Ir. Taryono, M sc.
2023 | Skripsi | FISIKA TEKNIK
Peningkatan
pemakaian listrik di Indonesia terus terjadi setiap tahun. Salah satu cara
mengatasi kebutuhan listrik di Indonesia adalah dengan memanfaatkan energi
bersih dari matahari. Potensi matahari Indonesia diperkirakan mencapai 200.000
MW. Namun pemanfaatannya masih terbilang sangat sedikit, yaitu sekitar 150 MW
atau setara 0,08 ?ri semua potensinya. Tingginya potensi ini dapat
dimanfaatkan sebagai alternatif untuk membangun PLTS pada lahan yang kosong.
Selain itu, pemerintah juga menargetkan pengadaan PLTS (Pembangkit Listrik
Tenaga Surya) di atap sebesar 3.600 MW sampai tahun 2025 melalui revisi
Peraturan Menteri ESDM Nomor 49 tahun 2018 tentang Penggunaan PLTS Atap.
Penelitian ini bertujuan untuk mendapatkan rancangan PLTS yang layak dari segi
teknis maupun ekonomi dari objek container grow di Pusat Inovasi
Agroteknologi UGM.
Perancangan
dilakukan dengan perangkat lunak PVsyst untuk menemukan konfigurasi yang
optimal, dengan memasukkan perhitungan beban kontainer, data meteorologis dari
meteoronom, serta biaya komponen. Selanjutnya dari hasil simulasi akan
dilakukan analisis teknis dan ekonomi untuk menemukan sistem yang paling
optimal.
Hasil dari
simulasi dan analisis, diperoleh rancangan sistem yang paling optimal adalah
modul PV JA Solar 330 Wp dengan kapasitas total 5,94 kWp dan sistem On-Grid.
Sistem dapat memproduksi sebesar 9033 kWh/Tahun, performa ratio 76,6%, solar
fraction 42%, nilai LCOE sebesar Rp612,65, Biaya Operational dan Maintenance
Rp1.096.663/tahun, NPV sebesar Rp3.280.762, Biaya modal awal Rp 64.876.321,
dan waktu kembali modal selama 11,3 tahun.
The increase in electricity
consumption in Indonesia continues to occur every year. One way to overcome the
need for electricity in Indonesia is to utilize clean energy from the sun.
Indonesia's solar potential is estimated at 200,000 MW. However, its
utilization is still relatively small, namely around 150 MW or the equivalent
of 0.08% of all its potential. This high potential can be used as an
alternative to building PLTS on vacant land. In addition, the government is
also targeting the procurement of PLTS (Solar Power Plants) with a roof of
3,600 MW until 2025 through the revision of Minister of Energy and Mineral
Resources Regulation Number 49 of 2018 concerning the Use of Rooftop PLTS. This
study aims to obtain a feasible PLTS design from a technical and economic point
of view from a container grow object at the UGM Agrotechnology Innovation
Center.
The design is carried out with
PVsyst software to find the optimal configuration, by including container load
calculations, meteorological data from meteorologists, and component costs.
Furthermore, from the simulation results, technical and economic analysis will
be carried out to find the most optimal sistem.
The results of
the simulation and analysis show that the most optimal sistem design is the 330
Wp JA Solar PV module with a total capacity of 5.94 kWp and the On-Grid sistem.
The sistem can produce 9033 kWh/year, performance ratio of 76.6%, solar
fraction of 42%, LCOE value of IDR 612.65, Operational and Maintenance Costs
of IDR 1.096.663/year, NPV of IDR 3.280.762, initial capital cost of Rp
64.876.321, and return time investment for 11,3 years.
Kata Kunci : PLTS, Kontainer, PVsyst