Laporkan Masalah

UNJUK ANALISIS KERJA SENSOR ROTASI R-1 MENGGUNAKAN REKAMAN DUA EKSPERIMEN LEDAKAN “TAIGER” DI TIMUR LAUT TAIWAN PADA 4 MARET 2008

BUDIARJO, Dr. Wiwit Suryanto, M.Si.

2014 | Skripsi | GEOFISIKA

Analisis unjuk kerja sensor rotasi portabel R-1 buatan Eentec dilakukan dengan memanfaatkan rekaman data dua ledakan eksperimen “Taiger” di Timur Laut Taiwan pada tanggal 4 Maret 2008. Rekaman data gerakan tanah menghasilkan tiga komponen translasi dan rotasi (utara-selatan [x], timur-barat [y], dan vertikal [z]). Analisis sensor rotasi R-1 yang dilakukan bertujuan untuk mengetahui kinerja sensor rotasi yang dapat mengukur komponen gerak rotasi secara langsung. Pada penelitian ini, data komponen rotasi hasil rekaman dari sensor rotasi R-1 buatan Eentec yang telah didapatkan, dibandingkan dengan komponen rotasi yang diturunkan dari analisis array pada waktu dan lokasi yang sama. Hasil perbandingan menunjukkan kesesuaian waveform antara komponen rotasi yang diukur langsung dengan turunan analisis array. Hasil xcorr dari ledakan N3 komponen-x 0,80741, komponen-y 0,89671 dan komponen-z 0,91543. Hasil xcorr dari ledakan N3P komponen-x 0,87427, komponen-y 0,8191 dan komponen-z 0,92099. Hasil ini menunjukkan bahwa komponen gerak rotasi dapat di ukur secara langsung dengan menggunakan sensor rotasi R-1 buatan Eentec.

The performance analysis of the sensor rotation R-1 portable made in Eentec was conducted by utilizing experimental data records of two \\"Taiger\\" explosions in Northeastern Taiwan on March 4th 2008. The Data recording of ground motion produces three translational and rotational components (north-south [x], east-west [y], and vertical [z]). Analysis of R-1 rotational sensor conducted aimed to investigate the performance of rotation sensor which can measure rotational motion components directly. In this study, the rotational component data recording of R-1 rotational sensor made in Eentec obtained was compared to the rotational component derived from the analysis of the array at the same time and location. The comparison shows similar waveform between directly-measured rotational component to the derivatived array analysis.. The results xcorr of the explosion N3 x-component is 0.80741, y-component is 0.89671 and z-component is 0.91543. Results xcorr of the explosion N3P x-components is 0.87427, y-component is 0.8191 and z-component is 0.92099. These results indicate that the rotational motion components can be measured directly by using R-1 rotational sensor made in Eentec.

Kata Kunci : Sensor Rotasi R-1, Array Translasi


    Tidak tersedia file untuk ditampilkan ke publik.