Rancang bangun robot arm 4-dof berbasis esp32 untuk sistem pick and place
Sebastian Gymnasrama Putra, Ir. Imroatul Hudati, S.T.,M.T.
2026 | Tugas Akhir | D4 Teknologi Rekayasa Instrumentasi dan Kontrol
Robot arm 4-DOF hasil rakitan mahasiswa sebelumnya yang tersimpan di laboratorium dalam kondisi tidak berfungsi—dua servo rusak, gripper aus, dan belum memiliki sistem elektronik—dirancang bangun ulang menjadi platform sistem pick and place berbasis mikrokontroler ESP32. Sistem menggunakan pengendalian posisi tetap (fixed-position atau teach-and-playback control), yaitu setiap posisi kerja robot (ready, pick, dan place) dikalibrasi secara manual dan disimpan sebagai preset sudut servo. Preset tersebut kemudian dijalankan secara berurutan ketika sensor ultrasonik HC-SR04 mendeteksi objek pada jarak kurang dari 3 cm. Forward kinematics dengan pendekatan trigonometri geometri digunakan sebagai alat bantu verifikasi matematis untuk memastikan preset sudut servo menghasilkan koordinat end-effector (X, Y, Z) yang sesuai dengan target, bukan sebagai metode kendali gerak secara real-time.
Hasil pengujian menunjukkan bahwa robot arm 4-DOF berhasil menjalankan urutan gerakan pick and place secara otomatis dengan tingkat keberhasilan sebesar 80% (8 dari 10 percobaan). Dua kegagalan disebabkan oleh gangguan sementara pada catu daya servo saat beban puncak, dan sistem kembali beroperasi secara normal pada percobaan berikutnya. Perhitungan forward kinematics pada posisi ready menghasilkan koordinat (0; 0; 26,66) cm, identik dengan hasil pengukuran fisik robot. Hasil tersebut membuktikan bahwa preset posisi yang digunakan telah sesuai dengan struktur mekanik robot.
A non-functional robot arm assembled by a previous student, featuring two damaged servos, a worn gripper, and no electronic control system, was redesigned and rebuilt into a 4-DOF pick-and-place platform based on the ESP32 microcontroller. The system employs fixed-position (preset) control using a teach-and-playback approach, in which each working position (ready, pick, and place) is manually calibrated and stored as a set of servo angle presets. These presets are executed sequentially when the HC-SR04 ultrasonic sensor detects an object within a distance of less than 3 cm. Forward kinematics based on a trigonometric-geometric approach is used solely as a mathematical verification tool to ensure that the servo angle presets produce end-effector coordinates (X, Y, Z) that match the target position, rather than serving as a real-time motion control method.
The test results show that the 4-DOF robot arm successfully executed the automatic pick-and-place sequence with an 80% success rate (8 out of 10 trials). The two failed trials were caused by temporary servo power supply disturbances under peak load, and the system recovered automatically during the subsequent trial. The forward kinematics calculation for the ready position produced coordinates of (0; 0; 26.66) cm, which were identical to the measured physical position of the robot. These results confirm that the predefined position presets are consistent with the robot's mechanical structure.
Kata Kunci : robot arm, pick and place, forward kinematics, ESP32, posisi tetap (preset)