Laporkan Masalah

Optimisasi Parameter Power System Stabilizer Menggunakan Particle Swarm Optimization Untuk Meningkatkan Stabilitas Sudut Rotor Generator Berbasis Simulasi

Muhammad Ali Ridha, Ir. Candra Febri Nugraha, S.T., M.Eng.

2026 | Tugas Akhir | D4 TEKNOLOGI REKAYASA ELEKTRO

Sistem tenaga listrik merupakan sistem dinamis yang mengalami perubahan kondisi operasi dan gangguan sehingga dapat menimbulkan ketidakseimbangan antara daya mekanik dan daya elektrik generator. Ketidakseimbangan tersebut memicu osilasi elektromekanik yang berpotensi menurunkan stabilitas sudut rotor, terutama pada sistem multimachine. Salah satu perangkat untuk meningkatkan redaman osilasi adalah Power System Stabilizer (PSS), namun penentuan lokasi pemasangan dan parameter optimal masih menjadi tantangan karena kontribusi setiap generator terhadap mode osilasi berbeda. Penelitian ini bertujuan menentukan lokasi pemasangan dan parameter PSS untuk meningkatkan performa small-signal stability. Studi dilakukan pada sistem IEEE 14 Bus menggunakan modal analysis dan participation factor untuk mengidentifikasi mode kritis serta generator dominan. Parameter PSS2A, meliputi stabilizer gain (Ks), washout filter (Tw), dan kompensator lead-lag (Ts1–Ts4), dioptimalkan menggunakan Particle Swarm Optimization (PSO) yang terintegrasi dengan DIgSILENT PowerFactory melalui DIgSILENT Programming Language. Evaluasi dilakukan melalui simulasi time-domain dengan gangguan hubung singkat tiga fasa dan fungsi objektif Integral Time Absolute Error (ITAE). Hasil penelitian menunjukkan bahwa G0008 dan G0001 merupakan lokasi PSS terpilih. Parameter hasil optimasi meningkatkan rasio redaman mode kritis dari 4,905% menjadi 7,452%, menurunkan ITAE sebesar 36,931% dibandingkan kondisi tanpa PSS, sedangkan PSS konvensional hanya 0,102%, serta mempercepat settling time sebesar 46–48%. Uji robustness dengan 30 independent runs menghasilkan koefisien variasi 0,010% pada G0001 dan 0,123% pada G0008. Implementasi pada sistem Timor 2025 melalui pemasangan PSS di PLTU Bolok dan PLTD Kupang menurunkan ITAE sebesar 8,525%. Hasil tersebut menunjukkan bahwa kombinasi analisis modal, participation factor, dan PSO efektif menentukan penempatan serta parameter PSS yang adaptif terhadap karakteristik sistem uji dan sistem operasi aktual secara konsisten

Power systems are dynamic systems that experience operating condition changes and disturbances, which may cause an imbalance between the mechanical input power and the electrical output power of generators. This condition gives rise to electromechanical oscillations that can reduce rotor angle stability, particularly in multimachine power systems. One method to improve oscillation damping is the Power System Stabilizer (PSS), but determining its optimal installation locations and parameters remains challenging because each generator contributes differently to the system oscillation modes. This study aims to determine the optimal PSS installation locations and parameter settings to improve small-signal stability performance. The IEEE 14-Bus system was analyzed using modal analysis and participation factor analysis to identify generators that predominantly contribute to the critical oscillation mode. The PSS2A parameters, including the stabilizer gain (Ks), washout filter (Tw), and lead–lag compensators (Ts1–Ts4), were optimized using the Particle Swarm Optimization (PSO) algorithm integrated with DIgSILENT PowerFactory through the DIgSILENT Programming Language. Performance was evaluated through time-domain simulations under a three-phase short-circuit disturbance using the Integral Time Absolute Error (ITAE) performance index. The results show that generators G0008 and G0001 were selected as the optimal PSS installation locations. The optimized parameters increased the damping ratio of the critical mode from 4.905% to 7.452%, improved system performance by 36.931?sed on the ITAE compared with the system without PSS, whereas the conventional PSS achieved only a 0.102% improvement, and reduced the settling time by 46–48%. Robustness analysis based on 30 independent runs produced coefficients of variation of 0.010% for G0001 and 0.123% for G0008. Implementation on the 2025 Timor power system, with PSS installed at PLTU Bolok and PLTD Kupang, improved system performance by 8.525?sed on the ITAE.

Kata Kunci : Modal Analysis, Optimisasi Parameter, Particle Swarm Optimization (PSO), Power System Stabilizer (PSS), Stabilitas Sudut Rotor

  1. D4-2026-497444-abstract.pdf  
  2. D4-2026-497444-bibliography.pdf  
  3. D4-2026-497444-tableofcontent.pdf  
  4. D4-2026-497444-title.pdf