Laporkan Masalah

COMMISSIONING LINK RADIO OPTIX RTN 900 MENGGUNAKAN SOFTWARE iManager WebLCT U2000 DI HUWAEI TECH INVESTMENT SEMARANG

ALIP WIDYANINGSIH, Nur Sulistyawati, S.T.,M.T.

2016 | Tugas Akhir | D3 TEKNIK ELEKTRO SV

Pada laporan proyek akhir ini akan dijelaskan perangkat dari produk Huawei yang merupakan salah satu perangkat yang mendukung transmisi jaringan microwave yaitu RTN (Radio Transmission Network) yang merupakan jalur transmisi sistem radio microwaveyang digunakan untuk menghubungkan atau membuat komunikasi antar jaringan baik itu jaringan komunikasi selular ataupun jaringan pribadi. Agar perangkat ini dapat beroperasi untuk mendukung proses transmisi jaringan maka diperlukan proses commissioning, proses commisioning adalah tahapan setelah proses instalasi hardware atau perangkat selesai dilakukan oleh installer. Proses commissioning pada link optik ini terdiri dari beberapa proses yang harus dilakukan yaitu proses input parameter mulai dari mengatur koneksi laptop, memulai software iManager, pencarian GNE (Gateway NE), memasukan parameter konfigurasi, merubah atribut NE, menambahkan boardmodule, mengecek interference, dan melakukan cross connection, yang nantinya pada hasil commissioning terlihat IF board dan ODU dikonfigurasi dengan benar pada proses penambahan board module. NE ID yang sudah sesuai dengan perencanaan jaringan, status board yang dapat diketahui normal atau tidaknya dengan melihat layout slot board pada NE explorer. Dan cross connection yang sudah terkonfigurasi dengan baik.

In the report the end of this project will be explained device from Huawei, which is one device that supports the transmission of microwave networks that RTN (Radio Transmission Network) which is a transmission line system of microwave radio which is used to connect or make a cross-network communications both mobile communications network or private network. So that the device can operate to support network transmission process will require the commissioning process, the process of commissioning is the next logical step after the installation of hardware or device is done by the installer. The commissioning process on the optical link consists of several processes that must be done is the input process parameters from managing laptop connections, start the software iManager, search GNE (Gateway NE), enter configuration parameters, change the attributes of NE, adding board module, check for interference, and cross connection, which later on results seen commissioning IF board and ODU are configured correctly in the process of adding a module board. NE ID which is in conformity with the planning of the network, status board that can be known whether or not normal to see the layout of the board slots on the NE explorer. And cross connection that has been configured properly.

Kata Kunci : commissioning, network transmission, device RTN

  1. D3-2016-351141-abstract.pdf  
  2. D3-2016-351141-bibliography.pdf  
  3. D3-2016-351141-tableofcontent.pdf  
  4. D3-2016-351141-title.pdf